SecurityMan PIR-SD Manual do Utilizador descarregar pdf (Página 14)

Wall

After clicking on the “Get System Time” pop up, a conrmation pop up will

appear letting you know that the time and date were set successfully. Click

OK to close the window and disconnect the PIR-SD from your computer.

NOTE: A “SysTime.bin” ﬁle will be created indicating that the date

and time was set correctly.

Finally, connect the PIR-SD to the USB power adapter and a solid red light

will appear in the motion detection window for 30-sec. After the red light

disappeared, the PIR-SD is ready for commands.

IMPORTANT NOTICE: Please avoid unplugging the USB power from the

PIR-SD as doing so will cause the system Date and Time to reset. To

playback recorded ﬁles, please remove the SD card from the PIR-SD to

playback on a media reader.

Mount the PIR-SD’s mouting bracket in the desired location and secure it

to the wall using the screws provided (use the green dry wall inserts when

applicable) as shown below.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 22 23

Sem comentários

SecurityMan PIR-SD Manual do Utilizador Página 14